Calibration

This example demonstrates one technique for calibrating sensor input. The board takes sensor readings for five seconds during the startup, and tracks the highest and lowest values it gets. These sensor readings during the first five seconds of the sketch execution define the minimum and maximum of expected values for the readings taken during the loop.

Step 1: What You Need?

1 x Arduino Board (Arduino UNO used in this tutorial)
1 x LED (Red)
1 x 220 Ohm Resistor 
1 x Analog sensor (a photoresistor will do)
1 x 10k Ohm Resistor 
1 x Mini Breadboard

Male-to-Male Jumper Wires 

Don't have components? Don't worry. Just click the component's name. 

Step 2: Build Your Circuit.

Analog sensor (e.g. potentiometer, light sensor) on Analog input 2. LED on Digital pin 9. Connect an LED to digital pin 9 with a 220 ohm current limiting resistor in series. Connect a photoresistor to 5V and then to analog pin 0 with a 10K ohm resistor to ground.

Step 3: Upload The Code.

1. Select the Arduino board type: Select Tools >> Board >> Select your correct Arduino board used.

2. Find the port number by accessing device manager on Windows. See the section Port (COM&LPT) and look for an open port named "Arduino Uno (COMxx)". If you are using a different board, you will find a name accordingly. What matters is the xx in COMxx part. In my case, it's COM3. So my port number is 3.

Select the right port: Tools >> Port >> Select the port number.

3. You can find this code in the example of Arduino IDE.
Select File >> Examples >> 03.Analog >> Calibration

Click press the "upload" button (see the button with right arrow mark).

Before the setup, you set initial values for the minimum and maximum like so:

int sensorMin = 1023;        // minimum sensor value
int sensorMax = 0;           // maximum sensor value

These may seem backwards. Initially, you set the minimum high and read for anything lower than that, saving it as the new minimum. Likewise, you set the maximum low and read for anything higher as the new maximum, like so:

// calibrate during the first five seconds
while (millis() < 5000) {
sensorValue = analogRead(sensorPin);
// record the maximum sensor value
if (sensorValue > sensorMax) {
sensorMax = sensorValue;
}
// record the minimum sensor value
if (sensorValue < sensorMin) {
sensorMin = sensorValue;
}
}

This way, any further readings you take can be mapped to the range between this minimum and maximum like so:

// apply the calibration to the sensor reading
sensorValue = map(sensorValue, sensorMin, sensorMax, 0, 255);

Download: 

Arduino software




Sources:https://www.arduino.cc/en/Tutorial/Calibration

Unknown

Author & Editor

My Robot Education Sdn. Bhd. (Robotedu.my) was founded in 2015 as the first robotics education centre in Malaysia to provide Arduino-based robotics courses for youths. Our vision is to be able to provide robotics education to every youth in Malaysia.