Thursday, July 14, 2016

Filled Under: , , , ,

Blink

Arduino Arduino UNO R3 Basic LED library

This example shows the simplest thing you can do with an Arduino to see physical output: it blinks an LED.

Step 1: What You Need?

1 x Arduino Board (Arduino UNO used in this tutorial)
1 x LED(Red)
1 x 220 ohm resistor


Optional:


Don't have components? Don't worry. Just click the component's name. 

Step 2: Build Your Circuit.

To build the circuit, connect one end of the resistor to Arduino pin 13. Connect the long leg of the LED (the positive leg, called the anode) to the other end of the resistor. Connect the short leg of the LED (the negative leg, called the cathode) to the Arduino GND, as shown in the diagram and the schematic below.

Most Arduino boards already have an LED attached to pin 13 on the board itself. If you run this example with no hardware attached, you should see that LED blink.

The value of the resistor in series with the LED may be of a different value than 220 ohm; the LED will lit up also with values up to 1K ohm.





Step 3: Upload The Code.

1. Select the Arduino board type: Select Tools >> Board >> Select your correct Arduino board used. 

2.  Find the port number by accessing device manager on Windows. See the section Port (COM&LPT) and look for an open port named "Arduino Uno (COMxx)". If you are using a different board, you will find a name accordingly. What matters is the xx in COMxx part. In my case, it's COM3. So my port number is 3. 

Select the right port: Tools >> Port >> Select the port number.


3. You can find this code in the example of Arduino IDE.
Select File >> Examples >> 01.Basics >> Blink



Click press the "upload" button (see the button with right arrow mark).




  
The first thing you do is to initialize pin 13 as an output pin with the line
pinMode(13, OUTPUT);

In the main loop, you turn the LED on with the line:
digitalWrite(13, HIGH);


This supplies 5 volts to pin 13. That creates a voltage difference across the pins of the LED, and lights it up. Then you turn it off with the line:
digitalWrite(13, LOW);

That takes pin 13 back to 0 volts, and turns the LED off. In between the on and the off, you want enough time for a person to see the change, so the delay() commands tell the board to do nothing for 1000 milliseconds, or one second. When you use the delay() command, nothing else happens for that amount of time.

Step 4: Test Your Circuit.

The circuit will turns on an LED on for one second, then off for one second. 


Once you've understood the basic examples, check out the BlinkWithoutDelay 
example to learn how to create a delay while doing other things.

Once you've understood this example, check out the DigitalReadSerial example to learn how read a switch connected to the board.

Download: 

Arduino software

Sources:[https://www.arduino.cc/en/Tutorial/Blink]

Unknown

Author & Editor

My Robot Education Sdn. Bhd. (Robotedu.my) was founded in 2015 as the first robotics education centre in Malaysia to provide Arduino-based robotics courses for youths. Our vision is to be able to provide robotics education to every youth in Malaysia.

0 comments:

Post a Comment

 

  • Copyright © Arduino Tutorial ™ is a registered trademark.
    Designed by Templateism. Hosted on Blogger Templates.